Star God v3 up for Pre-Order

I’m quite fond of the old Star God figure. It was the first full figure I produced through 3D-printing and resin-casting. It’s gone through a couple of versions already and, as the moulds for v2 were at the end of their life, I decided to take the opportunity to replace the physically-sculpted base with a digital one and a re-print of the components to make them easier to mould & cast. I also very slightly reposed the arms. The master mould has gone well, though highlighted a couple of potential problems, so I’ll be making the production moulds ASAP. I’m opening up pre-orders which I will fulfil starting next week, the 2nd of October.

Along with these pre-orders, I’m releasing a few existing pad designs I’ve brought over to tru/art-scale size. Cogs Veteran join the line-up, and all but the Spiked Veteran design get a Damaged variant. Hopefully, these will be of use!

I teased before the weekend that these would all release at the weekend and this post is going up on Monday. I did make them all available at about 22:00 last night, so technically I didn’t lie!

Ben.



Leave a Reply

Your email address will not be published. Required fields are marked *

*

By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close